Universal Home Remote - GMC 2006 Envoy Getting To Know Manual

Universal Home Remote

(if equipped)
The controls for this feature are located
on your overhead console.
Program the Universal Home Remote
• Turn the ignition OFF.
• Press and hold down the two outside
remote buttons until the indicator light
flashes; then release the buttons
(about 20 seconds — do not hold for
more than 30 seconds). Do not
repeat this step for the second or
third devices that you plan to add to
the Universal Home Remote system.
• Hold the end of your hand-held trans-
mitter up to three inches away from
the surface of the remote and press
and hold the transmitter button and
the button you wish to assign it to on
the remote.
• Continue holding both buttons (up
to 90 seconds may pass as the
remote is being programmed); the
indicator light will begin blinking
slowly, then more quickly. Program-
ming is complete when the light on
the remote flashes rapidly.
• Release both buttons.
• Press and hold the remote button
again. If the indicator light stays lit
constantly, programming is complete.
• Continue programming additional
devices using the transmitters, but do
not press the two outside buttons on
the remote again.
If the remote indicator light blinks rapidly
for two seconds and remains on, it
indicates that your device (usually a
garage door opener) has a "rolling
code." Continue with the following steps:
• Press the training button (sometimes
marked "LEARN" or "SMART") on the
garage door opener motor head unit,
making sure that the indicator light
flashes to confirm training mode.
• Within 30 seconds, press and hold
the remote button programmed in the
previous steps for two seconds.
• Press and release this button three
times, holding it for two-second
intervals to ensure that the remote
has been trained.
See Section 2 of your Owner Manual.
13