Table of Contents
Advertisement
Windows XP
1.
On the Windows Start menu, highlight Connect To and
then select Show All Connections to open the Network
Connections window.
If Connect To is not available, directly select Network
Connections, or select Control Panel and then double-
click Network Connections in the Control Panel window.
2.
In the Network Connections window, double-click Local
Area Connection.
3.
In the Local Area Connection Status window, click the
Properties button.
4.
In the Local Area Connection Properties window, select
Internet Protocol (TCP/IP), and then click the Properties
button.
5.
Select Use the following IP address and type an IP
address on the 192.168.168.0/24 subnet, such as
192.168.168.50, in the IP address field.
6.
Type 255.255.255.0 in the Subnet Mask field.
7.
Click OK in the Properties window.
8.
Click Close or OK in the Local Area Connection Properties
window for the settings to take effect.
Page 16
Configuring Appliance Settings
Configuring Appliance Settings
After registering your SonicWALL CDP on MySonicWALL and
connecting a management computer to it, you are ready to
configure the appliance for use on your network.
Changing the Password
1.
On the System > Settings page, click the Password tab.
2.
Type the desired password into the Password field, and
again into the Verify Password field, then click Apply.
Configuring Local Time Zone Settings
1.
On the System > Settings page, click the Time tab.
2.
Complete the fields as described in the table below, then
click Apply.
Field
Time (hh:mm:ss)
Date
Time Zone
Set Time
Automatically
using NTP
Description
Select the time in 24-hour format by
clicking the up or down arrows next to
each field (hours, minutes, seconds).
Select the date (month, day, year)
from the pop-up calendar.
Select your local time zone from the
drop-down list.
Select this checkbox to allow the time
to be set automatically using NTP.
Configure NTP servers on the NTP
tab.
Advertisement
Chapters
Table of Contents
