Table of Contents
Advertisement
Powering On and Connecting to the
Appliance
After registering your SonicWALL CDP appliance on
MySonicWALL, you are ready to turn on the appliance and
connect a computer to it for initial configuration.
1.
Place the SonicWALL CDP appliance and your
management computer next to each other for the
initialization process.
2.
Set the LAN IP address of your management computer to
a static IP address on the 192.168.168.0/24 subnet, such
as 192.168.168.50. For help with setting a static IP
address on your computer, refer to
Address on Windows - page
3.
Using the supplied crossover cable (red), connect the LAN
port of computer to the LAN port on the back of your
SonicWALL CDP appliance.
Ethernet Port
(in the rear)
4.
Securely attach each provided power adaptor to a provided
power cord.
Page 14
Powering On and Connecting to the Appliance
Configuring a Static IP
15.
Management
Station
5.
Connect the power adaptors to the back of the appliance,
and insert the plug ends into grounded 110/120V outlets.
For redundancy, plug the power adaptors into outlets on
different circuits.
6.
If the appliance does not power up immediately, press the
power switch on the front to turn it on.
7.
Open a Web browser on the computer and point it to:
http://192.168.168.169 (the default IP address of the
SonicWALL CDP appliance). The SonicWALL CDP login
screen displays.
Note:
One or more security warnings may display while
connecting to the SonicWALL CDP Web management
interface. Continue to the website, and accept the
certificate if required, to login to the SonicWALL CDP
appliance.
Advertisement
Chapters
Table of Contents
