Troubleshooting; Maintenance - Fellowes P-58Cs Manual

OPERATION
Disconnect power switch must be in ON (I) position to operate
shredder. Insert waste bag (Fellowes #36052) for easy disposal.
Continuous operation:
3-5 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3-5 minutes will trigger 15-minute
cool down period.

TROUBLESHOOTING

Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures.
Set to Reverse (R)
Alternate slowly back and forth
for 2-3 seconds
ATTENTION: If the SafeSense light remains on, you must engage the
®
SafeSense feature. (See SafeSense
®
SafeSense paper jam: If the SafeSense
®
the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense
the paper. Warning – when switch is in override position, the SafeSense
NOT function. Once the paper is cleared, reset the SafeSense

MAINTENANCE

Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Set to Off (O)
Shredder stops running
WARRANTY
LIMITED WARRANTY Fellowes, Inc. ("Fellowes") warrants the cutting blades of the machine to be free from
defects in material and workmanship for 5 years from the date of purchase by the original consumer.
Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 2
years from the date of purchase by the original consumer. If any part is found to be defective during the
warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option and
expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
PAPER
Check paper amount
Set to Off (O)
and plug in
CARD/CD
Set to Auto-On (l)
Set to Off (O)
and unplug
instructions below.)
®
feature activates (SafeSense
®
feature.
®
Follow oiling procedure below and repeat twice.
*Apply oil
across entry
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Set to Auto-On (l)
Hold card at edge
Gently pull uncut paper Set to
from paper entry. Plug in. Reverse (R)
Override Switch in order to perform steps above. Once the jam is cleared, reset the
light remains on) to cause the user to think
®
feature and clear
®
light will flash and the SafeSense
® ®
Set to Auto-On (I)
WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY
LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall
Fellowes be liable for any consequential or incidental damages attributable to this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid
worldwide, except where different limitations, restrictions, or conditions may be required by local law.
For more details or to obtain service under this warranty, please contact us or your dealer.
Feed into paper entry
and release
Feed into center of entry
and release
Indicator lights:
Yellow - SafeSense active
®
Yellow flashing - SafeSense
Make sure head is on basket correctly
Wait 15 minutes for motor to cool down
Remove and empty basket
Sensor light illuminated–paper jammed
feature will
SafeSense override switch
®
Active Not active
Shred one sheet Set to Reverse
(R) 2-3 seconds
15
Set to Off (O)
and unplug
not active
®
2