Standard & Optional Equipment - Rheem 05EAUER Manual

HEAT EXCHANGER
TWO-SPEED DRAFT
INDUCER MOTOR
DIRECT SPARK IGNITOR
STANDARD EQUIPMENT
Completely assembled and wired; 2 speed induced draft blower;
high and low pressure switches; 2 stage redundant main gas control;
blower compartment door safety switch; solid state time on/time off
blower control; limit control; transformer; direct drive multi-speed
blower motor. Furnaces are equipped with cooling/heating relay
and transformer (40VA) ready for air conditioning applications.
(Please note: a thermostat is not included as standard equipment.)
Flame sensor diagnostics; fused-protection (secondary).
NOTE: Furnace is not listed for use with fuels other than natural or L.P.
(propane) gas.
The complete terms of limited and other warranties are available
at our sales office, or through local installer.
IN-SHOT BURNERS
REMOTE SENSOR
OPTIONAL EQUIPMENT
All models can be converted by a qualified Rheem professional or
local service dealer to use L.P. (propane) gas without changing
burners. Factory approved kits must be used to convert from natural
to L.P. (propane) gas and may be ordered as optional accessories.
For L.P. (propane) operation, refer to Conversion Kit Index Form.
NOTE: For natural and L.P. (propane) gas models, direct spark ignition
is 100% lockout type.
WARNING
THIS FURNACE IS NOT APPROVED
OR RECOMMENDED
FOR USE IN MOBILE HOMES
Standard & Optional Equipment
Air
RGLQ Series
INTEGRATED
FURNACE
CONTROL