Product Specifications - Yard-Man 604 series Operator's Manual

Deck Wash System™ (If equipped)
Your tractor's deck may be equipped with a water port
on its surface as part of its deck wash system. Use the
Deck Wash System™ to rinse grass clippings from the
deck's underside and prevent the buildup of corrosive
chemicals. Complete the following steps AFTER EACH
MOWING:
1. Drive the tractor to a level, clear spot on your lawn,
near enough to a water sillcock (spigot) for your
garden hose to reach.
IMPORTANT: Make certain the tractor's discharge chute
is directed AWAY from your house, garage, parked cars,
etc.
2. Disengage the PTO (Blade Engage), move the shift
lever into the neutral position, set the parking brake,
and stop the engine.
3. Thread the hose coupler (packaged with your tractor's
Operator's Manual) onto the end of your garden hose.
4. Attach the hose coupler to the water port on your
decks surface. See Figure 21.
5. Turn the water on.
6. While sitting in the operator's position on the tractor,
re-start the engine and place the throttle lever in the
FAST (rabbit) position.
7. Disengage the parking brake.
8. Move the tractor's PTO (Blade Engage) into the ON
position.
9. Remain in the operator's position with the cutting
deck engaged for a minimum of two minutes, allowing
the underside of the cutting deck to thoroughly rinse.
10.Move the tractor's PTO (Blade Engage) into the OFF
position.
11. Turn the ignition key to the STOP position to turn the
tractor's engine off and engage the parking brake.
12.Turn the water off and detach the hose coupler from
the water port on your decks surface.
13.Repeat steps 4-11 on the opposite side of the cutting
deck.
Cutting Deck Removal
To remove the cutting deck, proceed as follows:
1. Place the PTO (Blade Engage) knob (or lever) in the
disengaged (OFF) position and engage the parking
brake.
2. Lower the deck by moving the deck lift lever into the
bottom notch on the right fender.
3. Remove the hairpin clip that secures the PTO cable to
the rear of the cutting deck. See Figure 22. Remove
the PTO cable and accompanying spring from the
cutting deck.
4. Remove the deck belt from around the tractor's
engine pulley (or electric PTO clutch, if so equipped).
Figure 21
If equipped
������� ����
��� �����
Figure 22
������� ���
Figure 23
25
������
6
Maintaining
Your Lawn
Tractor
IMPORTANT: Make
certain the tractor's
discharge chute is
directed AWAY from
your house, garage,
parked cars, etc.
On models with a 46-
inch deck, it may be
necessary to remove
the belt keepers from
around the engine pul-
ley, in order to remove
the PTO belt.
This Operators Man-
ual covers a range of

product specifications

for various models.
Characteristics and
features discussed
and/or illustrated in
this manual may not
be applicable to all
models. MTD LLC
reserves the right to
change product speci-
fications, designs, and
equipment without
notice and without
incurring obligation.