Ariens Sno-Thro 921011 Owner's/Operator's Manual page 18

Snow Clean-Out Tool
(Figure 16)
WARNING: Hand contact with the
rotating impeller is the most
common cause of injury associated
with snow throwers. Never use your
hand to clean out the discharge
chute.
Figure 16
To clear the discharge chute:
1. Shut off the engine.
2. Wait 10 seconds and make sure impeller
blades have stopped rotating.
3. Remove the snow clean-out tool (1) from
the auger housing and use it to remove
the clog from the discharge chute.
4. Replace the snow clean-out tool on the
auger housing.
Remote Deflector Control
(921013, 016, 017, 018, 020)
Place deflector into position before operation.
DO NOT throw snow any higher than
necessary.
Place deflector remote in a forward notch to
throw snow lower. Place deflector remote in a
rearward notch to throw snow higher.
Manual Discharge Deflector (921011,
012, 014, 015, 019)
ALWAYS position discharge chute deflector
at a safe angle before starting engine. DO
NOT throw snow any higher than necessary.
1. Push deflector handle forward or down
2. Pull deflector handle up or to the rear to
1
Discharge Chute
OS7102
Discharge chute rotates 200°.
ALWAYS position discharge chute in safe
direction and angle, away from operator and
bystanders, before starting engine.
GB - 18
to throw snow lower.
throw snow higher (Figure 17).
1
1. Deflector
Handle
Figure 17 OS7103