Miele CVA 5060 Operating Instructions Manual page 11

Warning and Safety instructions
~
The electrical safety of this machine
can only be guaranteed when
continuity is complete between it and
an effective earthing system which
complies with local and national safety
regulations. It is most important that this
basic safety requirement is present and
tested regularly, and where there is any
doubt the household wiring system
should be inspected by a qualified
electrician.
The manufacturer cannot be held liable
for the consequences of an inadequate
earthing system (e.g. electric shock).
~
The machine must only be operated
when built in, to ensure that all
electrical components are shielded.
Ensure power is not supplied to the
machine until after installation, repair
work or maintenance work has been
carried out.
~
Do not connect the machine to the
mains electricity supply by a
multi-socket unit or an extension lead.
These do not guarantee the required
safety of the machine (e.g. danger of
overheating).
~
The machine is not suitable for use
in the open air, even when installed in a
mobile unit (optional extra).
~
This equipment may only be used in
mobile installations such as ships if a
risk assessment of the installation has
been carried out by a suitably qualified
engineer.
11
~
Installation work and repairs may
only be carried out by suitably qualified
and competent persons in strict
accordance with current local and
national safety regulations. Repairs and
other work by unqualified persons
could be dangerous and the
manufacturer will not be held liable.
~
While the machine is under
guarantee, repairs should only be
undertaken by a service technician
authorised by the manufacturer.
Otherwise the guarantee will be
invalidated.
~
Faulty components must only be
replaced by genuine Miele original
spare parts. The manufacturer can only
guarantee the safety of the appliance
when Miele replacement parts are
used.
~
The machine is only completely
isolated from the electricity supply
when:
– the mains fuse is disconnected,
– the screw-out fuse is removed (in
countries where this is applicable),
– it has been switched off at the wall
socket and the plug has been
withdrawn.