Natural Gas Conversion - Whirlpool 30" Installation Instructions Manual

Natural gas conversion
1
n
Check that main gas supply line has been
shut off and the power supply cord is
disconnected.
2
n
Remove burner grates,
pressure
regulator
pressure
regulator
pktic
cover
Natural
Nat. gas
L.P. gas
DO NOT REMOVE THE PRESSURE REGULATOR.
3
n
Open broiler drawer to locate pressure
regulator.
Pressure regulator: Remove plastic cover. Turn
cap marked "L.P." on front of pressure regulator
counterclockwise with a wrench to remove. Do
Not disturb or remove the spring beneath the
cap. Turn the cap over and reinstall cap on
regulator so that the letter "N" is visible. Replace
plastic cover over cap.
air shutter
4
n
Cookto~
burners: Lift UD cooktop maintop
until it is held-in place by support rods.. Remove
shipping screws from each burner. Remove
burners.
orifice spuds
NAT
L.P.
etches
gas
manifold
ww ww
L.R. L.F.
R.F. R.R.
w Locate Natural gas orifice spuds in
literature package. All Natural gas orifice spuds
are stamped with "54". Remove L.P. gas orifice
spuds using a 3/8" combination wrench. Install
Natural gas orifice spuds to replace the L.P. gas
orifice spuds.
Place L.P. gas orifice spuds in plastic parts bag
for future use and keep with literature package.
Reinstall burners. Lower maintop to operating
position. Reinstall burner grates.
increase flame size
pre-set at factory
for Natural gas
6
woven burner: Use l/2" combination
wrench to loosen the orifice hood away from pin
(approximately 2 to 2-l/2 turns). The burner
flame cannot be properly adjusted if this
conversion is not made.
7
n
Broil burner: Use l/2" combination wrench
to loosen orifice hood away from pin
(approximately 2 to 2-l/2 turns). The burner
flame cannot be properly adjusted if this
conversion is not made.
8
w Complete operation checks in Section E,
Page 6. Check for proper flame. Natural gas
flames do not have yellow tips.
Page 8