Installing Modules - Pittsburgh SYSTEM 10.1 Manual And Patch Manual

Adding new modules to the case is a simple process. Please follow the instructions below to
ensure that new modules are installed safely and correctly.
Experiment with system layout by resting a few modules in the case before installation.
1. Switch the power off and unplug the power adapter from the back of the case.
2. The red stripe on the ribbon cable marks -12v. This stripe needs to line up with the -12v
pins on the module. Failure to match up the pins correctly can result in damage to one or
all the modules connected to the power supply.
3. Use a small tool to line up the needed sliding square nuts close to where the module will
be mounted.
4. Attach the module to the sliding nuts using the included panel screws. If installing more
than 1 module, do not tighten down the panel screws until all the modules are installed.
This will allow some room to shift the modules as needed.
5. Once all the new modules are installed, plug in the power adapter and switch on the case.
Carefully test each module to ensure it is working as expected.

INSTALLING MODULES

30