Important Instructions - Pittsburgh SYSTEM 10.1 Manual And Patch Manual

Read Instructions:
Please read the System 10.1 Synthesizer manual completely before use and retain for future reference.
IMPORTANT Ribbon Cable Power Information:
The System 10.1 combines a set of individual modules to create a complete instrument. The individual modules can be
rearranged, removed, and replaced with any compatible eurorack modules from Pittsburgh Modular and other manufacturers.
The System 10.1 uses a standard 16 pin eurorack power ribbon cable to connect the modules to the internal +12v / -12v / +5v
power supply. Please pay very close attention to the orientation of the ribbon cable when adding and removing modules. The stripe on the ribbon cable marks
-12v. This stripe needs to line up with the -12v pins on the power rail and the -12v pins on the module. Failure to match up the pins correctly can result in
damage to one or all the modules in the System 10.1. On the power rail, the -12v pins are clearly labeled. On the individual modules, the positive and
negative sides of the pin connectors are labeled next to the power header on either the top or bottom of the PCB.
Do NOT remove individual modules from the System 10.1 while synthesizer is plugged in.
Do NOT unplug ribbon cables from the System 10.1 or individual modules while the System 10.1 is plugged in.
Important Instructions – PLEASE READ
2