Accessories & Features - Britax MAXI GUARDSICT8300 A 2013 series Instructions For Installation & Use

CARE & MAINTENANCE
D. Replace headrest cover by lifting elastic over headrest wings and feeding through AHR Easy Adjust
Headrest lever. Clip in the press studs on the on the cover underneath the headrest wings.
D
Clip press stud
E. Refit the insert pad (if fitted) and Ez buckle (if fitted) or other accessories if required. If the headrest has
moved then reset the headrest so the shoulder straps are near the shoulder.
F. Refit to the vehicle.
See pages 35 to 37 to remove or replace any accessories.
ONLY USE BRITAX SAFE-N-SOUND SEAT COVERS THAT ARE DESIGNED AND TESTED
FOR USE WITH THIS PRODUCT.
34
Instructions for Installation & Use - Series No. 8300/A/2013
Replace
headrest cover
over headrest
wings
D
ACCESSORIES & FEATURES
Use of aftermarket accessories, that is, accessories not provided with this child restraint can reduce the
safety of the child restraint and may cause injury or death. Always follow the instructions covering the use
of accessories in this section or the instructions provided with accessory. If an aftermarket accessory is
used that is not recommended by Britax Safe-n-Sound then ensure that the accessory is for this restraint
and compliant with AS/NZS 8005 and stated as suitable for use with this child restraint.
The following instructions apply to accessories that may be supplied with this restraint at point of
purchase. If not, a variety of Britax Safe-n-Sound accessories are available from various retailers of Britax
Safe-n-Sound products.
POCKET (IF FITTED)
The pocket sewn on the trim is designed for your convenience. It can hold those necessary items that you
need at a moments notice. e.g. Bottle, face washer, toy etc.
CAUTION: If using the pocket to store filled bottles,
please ensure contents are not contaminated due to
prolonged storage.
PADDED INSERT (IF FITTED)
The padded insert is designed to snugly support
the young child for extra comfort. Simply place the
padded insert on the restraint between harness
straps and the restraint back. Ensure padded insert
is lined up with or below the shoulder straps.
SHOULDER PADS (IF FITTED)
Shoulder pads are designed to provide extra comfort
for baby or child and are easily fitted to the shoulder
harness straps by:
A. Pull apart fasteners and remove shoulder pads from
harness.
B. Re-fit shoulder pads to harness and attach
fasteners for use.
Instructions for Installation & Use - Series No. 8300/A/2013
Shoulder
Pads
Padded
Insert
EZ
Buckle
system
Cup
Cup
holder
holder
Messy Mat™
35