How To Use - Britax MAXI GUARDSICT8300 A 2013 series Instructions For Installation & Use

HOW TO USE

ADJUSTING SHOULDER HARNESS STRAP HEIGHT
Correct fitment of the harness is very important as it restrains the
child in the restraint. The harness must fit firmly around the upper
torso of the child and be positioned so as to leave the child's arms
and legs free. Adjust the headrest so that the sides of the headrest
are just above the shoulders. See the next page.
1. Harness shoulder slots in headrest
2. AHR Easy Adjust Headrest lever
3. Shoulder harness straps
4. Harness tongues & buckle
5. Lap strap slots
6. Crotch strap slots
7. Harness adjustment strap
8. Shoulder Height Markers
The shoulder straps must be in the slots which are nearest
to the child's shoulders, but not more than 25mm below the
child's shoulders. With this headrest design the shoulder
strap slot will usually be just above the shoulders.
NOTE: If child's shoulders touch the headrest side
wings, raise the headrest to the next headrest position.
NOTE: This child restraint does not require the straps
to be disconnected to adjust their height, only the
headrest needs to be moved to adjust the shoulder
strap positions.
24
Instructions for Installation & Use - Series No. 8300/A/2013
2
8
1
3 3
5 5
4
6
6
7
25MM
ADJUSTING AHR EASY ADJUST™ HEADREST AND HARNESS STRAP
HEIGHT
A. You do not need to remove the restraint from the
vehicle to adjust the harness or headrest positions.
Small adjustments maybe done with the child in the
seat. The child will need to lean forward to allow the
headrest to be adjusted.
To adjust the headrest; lengthen the harness, lift
the AHR Easy Adjust Headrest Lever at the top of
the headrest then pull up or push down so that the
shoulder strap slots are level with or slightly above
your child's shoulders. If the headrest is just above
the shoulders then the harness level will be correct.
B. To lengthen harness press harness adjustment
button or lift lever while pulling on both shoulder
straps evenly until the harness will accommodate
the child. Place tongues in harness tongue holders
(if fitted).
Instructions for Installation & Use - Series No. 8300/A/2013
HOW TO USE
Pull to
lengthen
Harness Tongue
Press
Holders (if fitted)
and hold
or lift
AHR Easy Adjust Headrest lever
B
25