Remote Control - Emerson RC188 Owner's Manual

Ceiling fan/light receiver & reverse module and 6-speed receiver
Table of Contents

Advertisement

TWO AAA
BATTERIES
BATTERY
COMPARTMENT
COVER
Figure 1
Installation of Storage
Bracket for SR600

Remote Control

A storage bracket is provided for holding
your remote control when not in use. If you
desire to use the bracket, install it on a
wall that is away from excess heat or
humidity (Figure 2).
TO INSTALL BRACKET TO WALL:
SLIDE THE COVER UP TO EXPOSE THE SCREW
HOLES FOR INSTALLATION
COVER
WALL
BRACKET
SCREW
HOLES (2)
Figure 2
Setting Operating
Frequency of SR600
Remote Control
Your remote control has code switches
which must be set in one of 32 possible
code combinations. The five levers
(numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up)
position. Change the switch settings as
follows:
REMOTE CONTROL
LEVERS
ON
1
2
3
4 5
I
CODE
SWITCHES
SR600 REMOTE
CONTROL
1. Slide the five switch levers in the
remote control to your choice of ON
(up) or down positions. Use a ball-point
pen or small screwdriver and slide the
levers firmly up or down.
2. When power is restored, push and hold
the fan OFF button (
seconds to set the code in the receiver.
3. If airflow is desired in the opposite
direction, press the (
wall control. The fan must be operating
at any speed for the reverse button to
function. The blades will turn in the
opposite direction and reverse the
airflow.
4. To set the desired fan speed, press the
(
) button to decrease the speed and
the (
) to increase the speed. The
LED display will light up to indicate the
new speed selected.
5. To set the light intensity, press and
release the LIGHT (
decrease the light intensity and the
LIGHT (
) button to increase the light
intensity. The light will turn on at the
light intensity previously selected.
6. The sixth switch marked ON and I is for
dimming control of lights: Set switch to
ON to allow for dimming of the lights.
Set switch to I for no dimming of the
lights such as for fluorescent bulbs.
SR650 REMOTE
CONTROL PROCEDURES
General
Your Emerson Ceiling Fan/Light SR650
Remote Control consists of hand-held
transmitter with wall mount and a receiver
which is mounted under the fan ceiling
cover. The remote control is designed to
separately control your ceiling fan speed
and light intensity.
The remote control transmitter is powered
by
two
CR2032
(inculded). Be sure to remove the batteries
when the control is not to be used for an
extended period of time.
Code switches in the transmitter and
receiver may be set in 32 different
positions. If your fan and light go on and
off without using your control, you may be
getting interference from other remote
4
) for 3 to 5
) button on the
) button to
Lithium
batteries

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rc212

Table of Contents