Troubleshooting - Emerson RC188 Owner's Manual

d. Connect the black supply wire to
the black/white receiver wire (AC
IN L).
e. Cut off the end of the blue and
yellow receiver wires and strip
back insulation 1/2" from the end
of the wires.
f. Connect the blue fan wire to the
blue receiver wire (BOTTOM
LIGHT).
g. Connect the yellow fan wire to the
yellow receiver wire (UPPER
LIGHT).
CAUTION: If your ceiling fan does NOT
have an uplight, there will be NO yellow
fan wire. In this case, cap the yellow
receiver wire using a wire connector
(supplied). If your ceiling fan does NOT
have a downlight, cap the blue receiver
wire using a wire connector (supplied).
10. nsert the connected ends of the wires
up through the open side of the
hanger bracket and into the outlet box
as shown in Figure 17.
HANGER
BRACKET
1-1/4"
THREADED
STUDS (2)
Figure 17
11. Screw two 1-1/4" threaded studs
(supplied with the ceiling fan) into the
tapped holes in the hanger bracket
(Figure 15).
12. Slide the receiver up and over the
13. Install the optional Emerson Light
NOTE: To prevent damage to the
receiver, turn "off" the electricity at the
wall
removing light bulbs on the ceiling fan
or light fixture.
Fan/Light Fails to Operate
• Check that the speed switch on the
fan is set to HIGH ( .... ) speed.
• Check that the light switch is on.
• Check that the battery is good
(red indicator light should light when
OUTLET BOX
any button is pressed).
• Check that the receiver is wired
properly.
RECEIVER
• Check that code switches in the
remote control and receiver are set in
the same position.
CEILING
COVER
Short Range
• If the remote control operates the fan
when close to it, but does not operate
it at a distance of 40 feet, try placing
the antenna wire outside of the ceiling
cover.
11
hanger bracket. Press the receiver
against the ceiling, holding it in place
while installing the ceiling cover in
accordance with the instructions in
the Ceiling Fan Owner's Manual.
Fixture in accordance with the
instructions in the Light Fixture
Owner's Manual. Use the screws
removed in Step 1.
switch before
Trouble Shooting
installing or