Tail Gear Section - THUNDER TIGER TTR4571 Assembly Manual

35.
Locate the steering arm, trim the outer hole away as it is
too long to install in the tail.
36.
Secure the steering arm on rudder torque rod with
3x3mm set screws. Then locate the bushing and press it
into the torque rod retaining plywood. Epoxy this plywood
piece in the tail with the rudder torque rod inserted.

Tail Gear Section

TAIL GEAR SECTION
37.
Locate three plywood pieces, glue them together as
shown.
38.
Secure the triple layers plywood on the tail gear mount
with 2.3x12mm washer wood screws as shown. Press the
blind mounting nuts in triple layers plywood which are for
mounting tail gear later.
39.
Locate the tail brace and bulkhead, trial fit them in the
fuselage as well as the tail gear mount assembly. Mark the
position where they are going to be glued. Glue the
bulkhead and tail brace first as shown on the photo, then
proceed to install the elevator pushrod.
13
Tail Bulkhead
Tail Brace