Vpn Config - Cisco SVP2000P User Manual

Shows the NAT TCP mapping table
Shows the NAT UDP mapping table
Transfer Type
Inside IP
Inside Port
Outside Port
Notice: After finish setting, click the Add button to add new mapping table; click the Delete button to delete the selected
mapping table.
Shows the outside WAN port IP address and the inside LAN port IP address.
Outside IP
Inside IP
Click the Add button to add new table; click the Delete button to delete the selected mapping table.
Notice: 10M/100M adaptive means the network card, and other equipment physical consultations speed, testing speed
under bridge mode near to 100M, in order to ensure the quality of voice and communications real-time performance, we
made some sacrifices of NAT under the transmission performance. Transmit with full capability only when system is idle,
so can not guarantee that the transmission speed reach to 100M.

4.3.6.4. VPN Config

This web page provides us a safe connect mode by which we can make remote access to enterprise inner network from
public network. That is to say, you can set it to connect public networks in different areas into inner network via a special
tunnel.
S T E P H E N T E C H N O L O G I E S C O . , L I M I T E D
T e l : + 8 6 7 5 5 8 9 3 5 2 6 0 6 / F a x : + 8 6 7 5 5 8 9 3 5 2 6 1 2 / E m a i l : S u p p o r t @ s t e p h e n - t e l e . c o m / U r l : w w w . s t e p h e n - t e l e . c o m
Select the NAT mapping protocol style, TCP or UDP
Set the IP address of device which is connected to LAN interface to do NAT mapping.
Set the LAN port of the NAT mapping
Set the WAN port of the NAT mapping
Set the outside Wan port IP address of DMZ.
Set the inside LAN port IP address of DMZ
/ 5 / F , B u i l d i n g N O . 1 , T o n g X i n I n d u s t r y Z o n e , H e n g G a n g , L o n g G a n g , S h e n z h e n , G . D , C h i n a , 5 1 8 1 1 5
S V P 2 0 0 0 P P B u s i n e s s P O E I P P h o n e U s e r M a n u a l
- 4 6 -