Table of Contents
Advertisement
q
w
BH
z
q
x
r
A
e
B
c
t
v
y
e
r
t
!0
Automatic Buttonhole
q Stitch pattern:
w Presser foot:
e Thread tension dial:
r Stitch length:
t Stitch width:
* The size of buttonhole is automatically set
by placing the button in the rear of the
automatic buttonhole foot R.
* The button holder of the foot takes a button
size up to 2.5 cm (1˝) in diameter.
* Make a test buttonhole on an extra piece of
the fabric, interfacing and seams of the
actual garment.
* Use interfacing on stretch fabrics.
z Raise the needle by turning the handwheel
toward you.
w
Raise the presser foot lifter.
Attach the automatic buttonhole foot R.
q Groove
w Pin
x Pull the button holder to the back A, and
place the button in it.
Push back the button holder toward you B
as far as it will go.
e Button holder
* If the button is extremely thick, make a test
buttonhole. If it is difficult to fit the button
through the test buttonhole, lengthen the
buttonhole by pulling the button holder
back to create a gap.
r Gap
c Pull the buttonhole lever downward as far
as it will go.
t Buttonhole lever
v Insert the fabric under the foot. Turn the
handwheel toward you one rotation and
remove the fabric to the left to draw both
u
threads to the left. Insert the garment under
the foot, and lower the needle at the
o
starting point. Then lower the automatic
buttonhole foot R.
y Starting point
i
Note:
Make sure there is no gap between the slider
and spring holder, otherwise the left and right
length will be different.
u Slider
i Spring holder
o There should be no gap.
!0 Sewing gap
34
R: Automatic
buttonhole foot
1–5
0.5–1
3–5
Hide quick links:
Advertisement
Table of Contents
