Samsung SNC-570 User Manual page 33

3. Please remove the cover of the auto iris lens connection plug
and solder the lens cable to the connector pin in the plug.
Pin No
No.1 Pin
No.2Pin
No.3 Pin
No.4 Pin
4. Please replace the auto iris lens connection plug cover and take
off the CCD protection cap, and then attach the auto iris lens to
the camera by screwing it in clockwise.
5. Please insert the connection plug that is connected to the auto
iris lens cable into the auto lens connector, which is located on
the side of the camera.
6. Please set the lens selection switch, located on the back of the
camera, to DC or VIDEO depending on the type of auto iris
lens which is being used.
Lens
DC
Damping -
Damping +
Drive +
Drive -
VIDEO
Red(power)
NC
White
(video signal)
Black(GND)
3.1. Lens Installation
29