Speaker Distance; The Input Assign Menu; The Auto Power Down Menu - Pioneer HTP-072 Operating Instructions Manual

Home menu
Adjust the level of each speaker as the test tone is emitted.
Note
• If you are using a Sound Pressure Level (SPL) meter, take
the readings from your main listening position and adjust
the level of each speaker to 75 dB SPL (C-weighting/slow
reading).
• The subwoofer test tone is output at low volumes. You
may need to adjust the level after testing with an actual
soundtrack.
6 When you're finished, press RETURN.
You return to the Manual SP Setup menu.
Tip
• You can change the channel levels at any time by press
, then press CH SELECT and LEV +/– on the
RECEIVER
remote control. You can also press CH SELECT and use
/ to select the channel, and then use / to adjust
the channel levels.

Speaker Distance

For good sound depth and separation from your system, you
need to specify the distance of your speakers from the
listening position. The receiver can then add the proper delay
needed for effective surround sound.
• For the assignment of the digital signal inputs, see
Selecting the audio input signal on page 20.
1 Select 'Manual SP Setup' from the Home Menu.
2 Select 'Speaker Distance' from the Manual SP Setup
menu.
1d.Speaker Distance
1.Manual SP Setup
a.Speaker Setting Front L
Center
b.X.Over
c.Channel Level Front R
d.Speaker Distance Surround R
Surround L
Subwoofer
Return
3 Adjust the distance of each speaker Using /.
You can adjust the distance of each speaker in 0.1 m
increments.
4 When you're finished, press RETURN.
You return to the Manual SP Setup menu.

The Input Assign menu

ANALOG IN1 audio input terminal is assigned to CD under
factory settings, but this can be changed to TV input.
1 Select 'Input Assign' from the Home Menu.
Ho me M e nu
2 Select 'Analog Input' from the Input Assign menu.
2.Input Assign
a.Analog Input
3 Select the desired input option for the ANALOG IN1
audio input terminal.
4 When you're finished, press RETURN.
You return to the Input Assign menu.
3.0 m
[ 3.0 m ]
[ 3.0 m ]
[ 3.0 m ]
[ 3.0 m ]
[ 3.0 m ]
Return
1 . Manual SP Setup
2.Input Assign
3.Auto Power Down
4.HDMI Setup
R e tu r n
2a.Analog Input
Analog CD
Return Return

The Auto Power Down menu

Set to automatically turn off the receiver after a specified time
has passed (when the power has been on with no operation
for several hours).
• Default setting: OFF
1 Select 'Auto Power Down' from the Home Menu.
Ho m e Me nu
3.Auto Power Down
1 . Manual SP Setup Auto Power Down
2.Input Assign
3.Auto Power Down
4.HDMI Setup
R e t ur n
2 Specify the amount of time to allow before the power
is turned off (when there has been no operation).
• You can select 2, 4 or 6 hours, or OFF (if no automatic
shutoff is desired).
3 When you're finished, press RETURN.
You return to the Home menu.
06
06
OFF
Return
31
En