Basic setup
Chapter 3:
Basic setup
Before setting up
This receiver allows you to adjust the system setup, using the
on-screen display (OSD) that is shown on the TV screen.
• The OSD will not appear if you have connected using the
HDMI output to your TV. Use composite connections for
system setup.
First, follow the procedure below to make sure that the OSD
screen is displayed.
1 Switch on the receiver and your TV.
2 Switch the TV input to the input that connects this
receiver to the TV through the corresponding composite
video cable.
For example, if you connected this receiver to the VIDEO
jacks on your TV, make sure that the VIDEO input is now
selected.
3 Press
RECEIVER
on the remote control, then press the
HOME MENU button.
The Home Menu of the OSD screen will be displayed on the
TV. If nothing appears on the screen, try to change the TV
format setting on the receiver (see below).
Changing the TV format setting
If the OSD screen is not displayed correctly, it may be that the
TV system is set incorrectly for your country or region.
1 Switch the receiver into standby.
2 While holding down the TUNE button, press and hold
the STANDBY/ON button for about two seconds.
The display shows the new setting (PAL or NTSC).
03
03
19
En