Visual Indicators - Metrologic MS7600 Horizon series Service Manual

7.2 VISUAL INDICATORS

There is a red LED and amber LED on the front of the MS7600. When the scanner is on, the flashing or constant
illumination of the LEDs indicates the status of the current scan and the scanner.
No Red or Amber LED
The LEDs will not be illuminated if the scanner is not receiving power from the host or
transformer.
When the laser is active, the green LED is illuminated. The green LED will remain
illuminated until the laser is deactivated.
Steady Amber and Single Re d Flash
When the scanner successfully reads a bar code, the red LED will flash and the scanner will
beep once. If the red LED does not flash or the scanner does not beep once, then the bar code
has not been successfully read.
After a successful scan, the scanner transmits the data to the host device. Some
communication modes require that the host inform the scanner when data is ready to be
received. If the host is not ready to accept the information, the scanner's red LED will remain
on until the data can be transmitted
Flashing Amber then Flashing Red
This indicates the scanner is in program mode. A razzberry tone indicates that an invalid bar
code has been scanned in this mode.
Or
If the unit is in sleep mode, each LED will flash once every 15
seconds.
This indicates the scanner may be waiting for communication from the host.
Steady Amber
Steady Amber and Steady Red
Steady Red, Amber Off
.
7-8