2-Way Cassette - LG ARNU073TUC4 Instruction Manual

INSTALL DECORATION PANEL

2-Way Cassette

2-Way Decoration Panel Installation
1. Install two decoration panel attaching screws on the cassette chassis. Tighten about
3/8 inch.
2. Remove the air inlet grille from the decoration panel. (Remove the hook for the air
inlet grille cord.)
3. Hook the decoration panel key hole on the screws in-
stalled, and slide the panel so that the screws
reach the key hole edge.
4. Tighten completely the two initially installed
screws and two additional screws.
5. Connect the louver motor connector and
display connector.
6. After tightening these screws, install the air
inlet grille (including the air filter)
48
Safety grille
Louver motor
Decorative panel
Push
Ratch pull
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 32: Decoration Panel Installation
Piping side
Inlet Grille
Attaching screws
Control box cover
Cover
Filter
Key holes
Decorative panel
attaching screws