Summary of Contents for Gravely 911094 - Pro 21SCH, 911095 - Pro 21CH, 911098 - LM21S, 911100 - LM21SW, 911394 - Pro 21SCH
Page 1
Walk Behind Lawn Mower Owner/Operator Manual Models 911094 - Pro 21SCH 911095 - Pro 21CH 911098 - LM21S 911100 - LM21SW 911394 - Pro 21SCH Transfer Coller l’autocollant du model & modèle et du numéro de serial number série dans cet encadré. label from Transferir aquí...
Page 2
We the undersigned, ARIENS COMPANY, certify that: Der Unterzeichnete, ARIENS COMPANY, bescheinigt, dass: Wij, de ondergetekenden, ARIENS COMPANY, verklaren dat: Undertegnede, ARIENS COMPANY, attesterer, at: La sottoscritta società ARIENS COMPANY certifica che: Nosotros, los abajo firmantes, ARIENS COMPANY, certificamos que: Undertegnede, ARIENS COMPANY, bekrefter at: Undertecknad, ARIENS COMPANY, intygar att: Allekirjoittanut, ARIENS COMPANY, vakuuttaa, että: My, nijej...
Page 3
Garanterad uppmätt ljudnivå (L ) – Representativ äänitehotaso (L poziom mocy akustycznej (L Som Garantido (L 911394 : 98 dB Ariens Company Brillion, WI 54110-0157 USA Signature Signature Unterschrift Handtekening Underskrift Firma Firma Signatur Namnteckning Allekirjoitus Podpis Assinatura 911394 ) in dB –...
UNAUTHORIZED REPLACEMENT PARTS Use only Gravely replacement parts. Replacing any part on this vehicle with anything other than a Gravely authorized replacement part may adversely affect the performance, durability, or safety of this unit and may void the warranty. Gravely disclaims liability for any claims or damages, whether warranty, property damage, personal injury or death arising out of the use of unauthorized...
NOTATIONS NOTE: General reference information for proper operation and maintenance practices. IMPORTANT: Specific procedures or information required to prevent damage to unit or attachment. PRACTICES AND LAWS Practice usual and customary safe working precautions, for the benefit of yourself and others.
Page 7
Read, understand and follow all safety practices in Owner/Operator Manual before beginning assembly. Failure to follow instructions could result in personal injury and/or damage to unit. ALWAYS disconnect wire from spark plug before assembly. Unintentional engine start up can cause death or serious injury. Complete a walk around inspection of unit and work area to understand: •...
Page 8
When side discharging, ALWAYS install side discharge deflector. ALWAYS shut off engine, allow blade to stop and disconnect spark plug wire before clearing clogs or cleaning unit. Check grass bag for wear, damage, and/or deterioration. Replace only with Gravely original equipment replacement parts for safety.
Sharp edges can cut or amputate fingers or a hand. Wrap blade or wear sturdy gloves to service. Use only replacement parts designed for your unit. See your Gravely Dealer. Allow engine to cool before storing in any enclosure. ALWAYS clean unit before extended storage. See engine manual for proper storage.
CONTROLS AND FEATURES Figure 5 1. Engine/Blade Control 2. Wheel Drive Control (911094, 098, 100, 3. Adjustable and Folding Handlebars 4. Swivel Wheel Lock (911100) 5. Grass Bag 6. Rear Door 7. Fuel Tank and Cap 8. Fuel Shutoff Valve (911094, 095, 394) 9.
CONTROLS AND FEATURES See Figure 5 for locations. WARNING: Improper operation can lead to injury. Learn what the controls do and how they work. Thoroughly read and understand entire Operator Manual. CAUTION: AVOID INJURY. Read and understand the entire Safety section before proceeding.
Page 12
Swivel Wheel Models (911100) To change front wheel cutting height, insert height adjuster pin into the holes that match the desired cutting height and fasten with key ring (Figure 7). To change rear wheel cutting height, move cutting height levers one notch at a time to set the desired cutting height.
Swivel Wheel Lock (911100) CAUTION: Avoid loss of control. Lock swivel wheels when mowing on a slope or hill. Do not mow on steep slopes. To hold wheel straight: 1. Push swivel wheel lock forward. 2. Push unit forward until wheel locks in place.
Grass Bag Removal 1. Shut off unit. 2. Lift rear door. 3. Use handle to lift bag off mounting flange. 4. Close rear door. NOTE: Empty grass bag and clean mower pan after each use. DO NOT allow grass clumps or a grass coating to collect inside of grass bag or mower pan.
Mulching Tips For best mulching performance, cut no more than 1 inch (2.54 cm) of grass per cutting. CAUTION: AVOID INJURY. Read and understand the entire Safety section before proceeding. Gravely Dealers will provide any service, parts or adjustments which may be required to keep your unit operating at peak efficiency.
2. Torque bolt to 37.5 - 50 lbf-ft (51-68 N•m) (bolt should fully compress lock washer). 3. Connect spark plug wire. Sharpen the Mower Blades CAUTION: DO NOT sharpen mower blades while on unit. An imbalanced mower blade will cause excessive vibration and eventual damage to unit.
Swivel Wheels (911100) See Figure 10. Use Sten Mix Hi-Temp Grease or equivalent on the lube fittings. Order P/N: 00036800 - 3 pack of 3 oz. cartridges. Lube Fitting Figure 10 SERVICE AND ADJUSTMENTS CAUTION: AVOID INJURY. Read and understand the entire Safety section before proceeding.
911098, 100 Hole Figure 11 911094, 095, 394 1. Handlebar 2. Adjustment Hole 3. Support Bracket Figure 12 ENGINE/BLADE CONTROL ADJUSTMENT To adjust engine/blade control: 1. Loosen cable nuts away from bracket. OM1800 OM1010 2. Squeeze z-bend bracket at engine end of cable toward front of unit and hold in place.
4. Tighten lower cable nut to 1/8" (3 mm) below bracket. Release z-bend bracket. OM1020 5. Tighten upper cable nut until bracket is secure between cable nuts. OM1030 6. Engage engine/blade control. Measure distance between middle of z-bend and cable bracket. Measurement should be as shown below.
WHEEL DRIVE CONTROL ADJUSTMENT (self-propelled models) See Figure 14. 2-1/4" to 2-3/4" (5.7 to 7 cm) 1. Handlebar Indentation 2. Wheel Drive Control 3. Traction Cable 4. Cable Nuts Figure 14 The wheel drive must start to engage when wheel drive control is between 2-1/4" and 2-3/4"...
CAUTION: AVOID INJURY. Read and understand the entire Safety section before proceeding. IMPORTANT: NEVER spray unit with high- pressure water or store unit outdoors. Store mower in a cool, dry, protected location. Cleaning Clean unit thoroughly with mild soap and low pressure water.
PROBLEM PROBABLE CAUSE Wheel drive 1. Wheel drive control not engaged. does not 2. Drive belt out of position. engage (Self- Propelled models) 3. Drive belt worn or damaged. 4. Rear wheels in different cutting heights. 5. Idler spring detached. 6.
Model Number Description Length - in (cm) Height - in (cm) Width - in (cm) Actual Weight - lbs (kg) Cutting Width Cutting Height - in. (cm) Engine Model Engine Power - HP (kW) @ Maximum RPM Max Rotation Speed of Cutting Edge - RPM (min Governed RPM Displacement Cu.
Page 25
Warranty for Models 911098, 100 GB - 25...
Page 26
GRAVELY A Division of Ariens Company 655 West Ryan Street P.O. Box 157 Brillion, WI 54110-0157 920-756-2141 Fax 920-756-2407 www.gravely.com...