Setup Menu - Sony KDL-46V2000 Operating Instructions Manual

Setup menu

Auto Startup
Video Labels
Auto S Video
Timer Settings
26
GB
Starts the "first time operation menu" to tune in available digital and analog
channels. Usually, you do not need to do this operation because channels already
tuned when the TV was first installed (page 6). However, this option allows you to
repeat the process (e.g. to retune the TV after moving house, or to search for new
channels that have been launched by broadcasters).
Assigns a name to any equipment connected to the side and rear jacks. The name will
be displayed briefly on the screen when the equipment is selected. You can skip input
signals from connected equipment that you do not want displayed on the screen.
F f
1 Press / to select the desired input source, then press
F f
2
Press / to select the desired option below, then press
Equipment labels: Uses one of the preset labels to assign a name to connected
equipment.
"Edit": Creates your own label. Follow steps 2 to 4 of "Program Labels" (page 30).
"Skip": Skips an unnecessary input source.
Selects the input signal from S video jack
both connected.
"On": Switches automatically between the S video jack and the composite video
jacks depending on the cable connection.
"Off": Activates the composite video jacks.
Sets the timer to switch on/off the TV.
Sleep Timer
Sets a period of time after which the TV automatically switches itself into standby
mode.
When the "Sleep Timer" is activated, the
lights up in orange.
Tips
• If you switch off the TV and switch it on again, "Sleep Timer" is reset to "Off".
• "TV will soon turn off by Sleep Timer" appears on the screen one minute before the TV
switches to standby mode.
You can select the options listed below on the Setup
menu. To select options in "Settings", refer to "Picture
menu" (page 20).
1/2 when
(Timer) indicator on the TV (front)
.
.
1/2 jacks are
/