Meridian DSP8000 User Manual page 49

To connect to other Meridian G Series or 800 Series equipment
808 Anniversary System CD Player
MERIDIAN
COMMS
Meridian Comms lead
In a system of Meridian products, one of the products
acts as the controller for the system, receiving infra-red
commands from the MSR+ and then, if appropriate,
relaying them to the other products via the Comms link.
The following automatic setup procedure should be
used to set up the Comms correctly between several
products:
• Connect one of the DIN COMMS sockets on the
back panel of the 808 to one of the COMMS sockets
on another G Series, 00 Series, or 800 Series unit,
using the Comms leads provided with the products.
The sequence in which you connect the units is not
important.
• Switch all the units to standby.
• Press Clear (remote).
Auto
Each unit will display:
One unit will then be designated as the controller.
Controller
The display shows:
All the other units will be configured as non-controllers.
G Series, 500 Series, or 800 Series unit
MERIDIAN
COMMS
The displays show: Not Con.
If for any reason the automatic setup does not work,
make sure you are operating the remote from a
position where all the units can receive the infra-red,
and try again.
If this fails:
• Restore the default operation by selecting one of the
standard types; see Choosing a standard setting ,
page .
Do not, under any circumstances, connect any
equipment other than Meridian G Series or 800
Series to any socket marked COMMS on the back
of the product.
9
Installing the 808
Anniversary System
CD Player