Panasonic KX-TG3651BX Operating Instructions Manual page 32

TG3651BX(e).book Page 32 Monday, May 31, 2010 8:51 AM
Useful Information
Making/answering calls, intercom
Problem
Noise is heard, sound cuts in
and out.
The handset and/or base
unit does not ring.
I cannot make a call.
I cannot make a voice
announcement.
Caller ID
Problem
Caller information is not
displayed.
Caller information is
displayed late.
Time on the unit has shifted.
When you view the entry in
the caller list, the date and
time are displayed
incorrectly.
32
Cause/solution
L You are using the handset or base unit in an area with high electrical
interference. Re-position the base unit and use the handset away
from sources of interference.
L Move closer to the base unit.
L If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line jack.
Contact your DSL/ADSL provider for details.
L The ringer volume is turned off. Adjust the ringer volume (page 15).
L Night mode is turned on. Turn it off (page 24).
L The dialing mode may be set incorrectly. Change the setting (page
12).
L The handset is too far from the base unit. Move closer and try again.
L The other unit is in use. Try again later.
Cause/solution
L You must subscribe to Caller ID service. Contact your service
provider/telephone company for details.
L If your unit is connected to any additional telephone equipment such
as a Caller ID box or cordless telephone line jack, plug the unit
directly into the wall jack.
L If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line jack.
Contact your DSL/ADSL provider for details.
L Other telephone equipment may be interfering with this unit.
Disconnect the other equipment and try again.
L Depending on your service provider/telephone company, the unit
may display the caller's information at 2nd ring or later.
L Move closer to the base unit.
L Incorrect time information from incoming Caller ID changes the time.
Set the time adjustment to "Off" (page 22).
L The date and time may be set incorrectly or the power failure may be
occurred. Set the date and time again (page 12).