Display Information - Kalerm KLM1601 Operation Manual

Display information

●
This chapter will instruct you the information shows on the
screen and the solutions.
EMPTY TRAY
EMPTY GROUNDS
FILL WATER TANK
FILL BEANS
FILL POWDER
19
INSTALL TRAY
UNIT EMPTY
TEMPERATURE HIGH
TEMPERATURE LOW
ERROR 1
PRESSURE HIGH
VALVE RESET
RESTART MACHINE
Causes
If the water drip tray is full, any
function of making beverage will
be out of service.
If the coffee grounds container is
full, any function of making
beverage will be out of service.
If water in the water tank is used
up, any function of making
beverage will be out of service.
If coffee beans in the bean
container are used up, function of
making coffee will be out of
service.
There is not enough coffee powder
in the powder container.
The drip tray is not installed
correctly; any function is out of
service.
The water in the pipe inside the
machine is not enough; any
function is out of service.
Temperature of the machine is too
high, the machine cannot be used.
Temperature of the machine is too
low, the machine cannot be used.
The coffee machine failures, may
not be able to be used.
1. Using dark roasted coffee beans
or over fine coffee powder; 2. The
filter of the brewer is clogged.
Dispenser valve is blocked.
Solutions
Take the drip tray out, empty the
waste water in the drip tray and
reinstall it to the machine.
Take the coffee grounds container
out, empty the coffee grounds
container and reinstall it.
Fill the water tank with water.
Add beans into bean container,
and press the rotary button to
release.
Next time when making coffee
with coffee powder, please put a
full spoon of powder.
Install the drip tray correctly.
Press the rotary button to release,
to run the water replenishing system.
Power off the main power, and use
it 1 hour later.
Increase environmental temperature
to above 10℃.
1. Power off, restarting up
unresolved, please pull out the plug.
Contact with customer sevice
center.
1. Adjust grinder wheel to rougher;
2. Start brewer cleaning
procedure(refer to P12).
Restart coffee machine.
2. If still