Table of Contents
Advertisement
Top View
NOTE: Environments with
higher pollutant levels may
cause users to replace their
filters sooner than 6 months.
To order replacement filters
visit
www.allergyandair.com
1-855-302-6628
or call
5
Control Panel Overview
.
POWER BUTTON
Pressing the Power Button once will turn the unit on. By
default, the unit will begin to operate in AUTO Mode and
the indicator light will illuminate. Pressing this button a
second time enables SLEEP Mode. The unit will continue
to operate in the previous settings, but will turn off all but
the Power Button's indicator light. Pressing this button a
third time turns the unit off.
FILTER BUTTON
This air purifier has an internal timer to alert when the
filters should be replaced. The indicator light to the left of
this button will illuminate after 6 months of run time. Once
the new filters are installed hold this button for 5 seconds
to reset the timer. This will also turn the indicator light off.
TIMER BUTTON
Pressing the Timer Button enables an automatic shutoff for
time frames of four, eight, and twelve hours. The unit will
stay on for the allotted time. The indicator lights above this
button will indicate the respective set time frame. The
Timer can be turned off by pressing this button until no
indicator lights are illuminated.
SPEED BUTTON
There are four fans speeds to choose from – Low,
Medium, High, and Turbo. Pressing the Speed Button will
alternate through these settings. If the unit is in AUTO
Mode pressing the Speed Button once will set it to the Low
fan speed and turn off AUTO Mode. The indicator lights
above this button will indicate the respective fan speed.
AUTO BUTTON
Pressing the Auto Button enables AUTO Mode. The air
purifier will select the appropriate fan speed based on the
air quality level. Press again to turn off AUTO Mode.
AIR QUALITY INDICATOR LIGHTS
RED - High level of contaminants.
BLUE - Moderate level of contaminants.
GREEN – Low level of contaminants
Remote Control Sensor
Advertisement
Table of Contents
