U-Line 1224DWR User Manual page 17

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
SIDE-TO-SIDE ADJUSTMENT
The drawer will need a Side-
to-Side Adjustment if, when
viewed from the top, the
drawer front is not square with
the sides of the cabinet. This
is caused by one of the slides
being mounted too far forward
on the unit's liner.
Minor Adjustment:
Note: The mounting holes on
the slide are slightly larger
than the screws' diameter.
1. Loosen the slide's
mounting screws.
2. Push the slide backward.
3. Retighten the screws.
Severe Adjustment:
Note: The slides have extra
mounting holes that may be
used.
1. Remove the slide's
mounting screws.
2. Reposition the slide so it is
the same distance from
the front of the liner as the other slide. Measure to
confirm.
3. Mark new drilling holes using different sets of mounting
holes on the slide.
Note: Front location holes are shown. Corresponding rear
holes will also need to be marked.
4. Drill all the new holes with a #30 drill bit.
5. Remount the slide.
Not Aligned Side-to-Side
Top View of Unit
Loosen
Mounting Screws
Push Slide
Backward
Mark and Drill New
Mounting Holes
Push Slide
Backward
FRONT-TO-BACK ADJUSTMENT
The drawer will need a Front-
to-Back Adjustment if, when
viewed from the side, the
drawer front is cocked
forward or back. This is
caused by the front slide
mountings not being level
with the rear slide mountings.
Minor Adjustment:
Note: The mounting holes on
the slide are slightly larger
than the screws' diameter.
1. Loosen one slide's
mounting screws.
2. Level the slide.
3. Retighten the screws.
4. Repeat procedure for the other slide.
u-line.com
Not Aligned Front-to-Back
Side View of Unit
Screws Should
Be Loose
Level the Slide
Drawers 2