Installation And Wiring; Wiring Information For The Av2Sm; Using The Cc-Rel Connection Cable; Operation - AMX PT10-PRV 2 X 1 Instruction Manual

Installation and Wiring

This section covers the steps necessary to connect and operate a PT10-PRV 2 x 1 Video Preview
System. Before continuing, verify that you have received the correct components for your package.
Refer to FIG. 2 for more information.

Wiring Information for the AV2SM

VIDEO OUTPUT
(BNC connector)
VIDEO INPUT A
(BNC connector)
FIG. 2 Front and rear views of the AV2SM

Using the CC-REL connection cable

Use the CC-REL relay control cable (6-pin captive-wire to 8-pin captive-wire) to connect the
AV2SM to the AXB-REL8, as shown in FIG. 3.
SELECT
GND -
INPUT A connector
FIG. 3 CC-REL relay control cable connections

Operation

Setting camera stations 1 and 2 on the AXP-PLV controller will switch the appropriate video to the
touchpanel preview screen.
PT10-PRV 2 x 1 Preview Switcher System
Front panel
Rear panel
AXB-AV2SM
2A
2B
AXB-REL8
relay contacts 1-4
Installation and Wiring
12 VDC power
supply connection
VIDEO INPUT B
(BNC connector)
INPUT A connector
(6-pin captive-wire)
3