Am-Fm Stereo With Cassette Tape And Automatic Tone Control (Option) - GMC Yukon Owner's Manual

AM-FM Stereo with Cassette Tape and
Automatic Tone Control (Option)
. . . .
. . . . . .
. . . . . . . . . . . . . . . . .
. .
. . .
. . . .
Playing the Radio
PWR-VOL: Press this knob to turn the system on and
off. Turn this control clockwise to increase the volume
and counterclockwise to decrease the volume. The faster
the PWR-VOL knob is rotated, the quicker the volume
is increased or decreased.
RECALL: Press this button to switch between the clock
and the radio station frequency displayed when the radio
is on. Also, press this button to display the time when
the ignition is off.
S C V This is the Speed-Compensated-Volume (,SCV)
knob. Move the control ring behind the PWR-VOL knob
clockwise to adjust the SCV. Set the volume at the desired
level. As you drive, the SCV automatically increases the
volume, as necessary, to overcome road and wind noise at
any particular speed. The volume should always sound the
same. Each clockwise position on the control ring allows
for more compensation at a faster rate.
Finding a Station
AM-FM: Press this button to switch between AM, FMl
and FM2. The display will show your selection.
TUNE: Press lightly on this knob to release
it
from its
stored position. Rotate the knob clockwise to increase
frequency and counterclockwise to decrease frequency,
When finished tuning, press the knob again to return it
to its stored position.
SEEK: Press the right arrow to tune to the next higher
station and the left arrow to tune to the next lower station
and stay there. The sound will mute while seeking.
SCAN: Press and hold SEEK for two seconds until
SCAN appears on the display. SCAN allows you to
listen to stations for a few seconds. The receiver will
continue to scan and momentarily stop at each station
until you press the button again. The sound will mute
while scanning.
3-14