Table of Contents
Advertisement
Removing the Solid State Drive
1.
Turn off the computer, and turn it over and remove the battery (see page
and component bay cover (see page
2.
The SSD slot is at point
3.
Remove screw
, and the SSD
2
4.
Replace the SSD by angling it as illustrated, and then fit the connector firmly into
the slot.
5.
The SSD module's pin alignment will allow it to only fit one way. Make sure the
module is seated as far into the slot as it will go. DO NOT FORCE the module; it
should fit without much pressure.
6.
Press the SSD module down towards the mainboard and replace screw
the component bay cover.
1
6 - 4/6 -
5).
on the mainboard.
1
will pop-up and you can then remove it
3
2
3
Upgrading The Computer
6 -
3)
.
and
2
4
Upgrading the Hard Disk Drive 6 - 11
Figure 6 - 8
Component Bay -
SSD Removal
6
Advertisement
Table of Contents
