Attaching The Stand - Alba 24/207 User Manual

Attaching The Stand

To complete the stand installation you will require a cross head screw driver.
The Stand Installation pack comes with two different
types of screws.
fi g 1) Attach the stand neck to the rear of the TV set.
fi g 2) Secure the neck to the TV using the
(A) 3 x M (4x12) screws provided.
fi g 3) Peel off the protective plastic cover then attach
the stand base to the stand neck.
fi g 4) Secure the base to the neck using the
(B) 4 x ST (4x12) screws provided.
HELPFUL ADVICE FOR FIRST TIME STAND INSTALLATION
When securing the self-tapping screw/s into the base of the stand (on fi rst installation) the screw/s will be
naturally tight as they create a thread in the plastic of the stand neck in order to support a TV of this size.
a) Ensure the cross head screw driver tip fi ts correctly into the head of the
screw and that it is not too big or small.
b) Screw in all screws individually and partially before tightening all of the
screws fully.
c) If they become very tight try loosening them slightly and then re-tightening them once again as this will
continue the process of creating the thread for the screws.
For any help concerning set up and use of your TV please call the Customer Helpline: 0871 2000 463
10
(A) 3 x M(4x12) (B) 4 x ST(4x12)
1
3 x
M (4x12)
2
1 1/2
3
4
4 x ST (4x12)