Screen Menu Options; Auto Adjustment; Adjusting Horizontal/Vertical Position; Picture Phase Adjustments - LG MT-42PZ40B Owner's Manual

Screen Menu Options

Auto Adjustment (RGB1 (PC) mode only)
- Automatically adjusts picture position and minimizes image shaking.
- Although the image is still not correct, your Monitor is functioning properly but needs further adjustment.
1. Press the AUTO CONFIG. button to run Auto configure.
• If the position of the image is still not correct, try Auto adjustment again.
2. If picture needs to be adjusted more after Auto adjustment in RGB1 mode, you can
manually adjust the image position and Phase .
Adjusting Horizontal/ Vertical Position
- You can only adjust V-Position/H-Position in COMPONENT (480p) or RGB1(PC).
1. Press the MENU button and then use
2. Press the G G button and then use
3. Press the G G button and then use
4. Press the button and then use the
G G
zontal or vertical position.
• The adjustment range of V-Position is -50~+50.
• The adjustment range of H-Position is -100~+100.
• If you install the monitor vertically on the wall, the adjustment range of V-Position / H-
Position may change.
• Based on the PC resolution, the adjustment range of V-Position/H-Position may
change.
• Based on input signal, the position of the picture may not change even though you
have adjusted the horizontal or vertical position with this function.
5. Press the MENU button.
Picture Phase Adjustments (RGB1 (PC) mode only)
- If the picture isn't clear after auto adjustment and especially if characters are still jittery, adjust the picture phase
manually.
1. Press the MENU button and then use
2. Press the G G button and then use
3. Press the G G button and then use
4. Press the button and then use the
G G
• The adjustment range of Phase is 0 ~ 63.
5. Press the MENU button.
button to select the SCREEN menu.
D D / E E
button to select Screen adj. .
D D / E E
button to select V-Position or H-Position .
D D / E E
button to adjust until you get desired hori-
F F / G G
button to select the SCREEN menu.
D D / E E
button to select Screen adj. .
D D / E E
button to select Phase .
D D / E E
button to adjust phase.
F F / G G
Screen
Screen adj. G G
To Set
VGA Mode
ARC
PIP/DW
Zoom
Screen adj.
Auto configure
[V-Position] G G 0
[H-Position]
Phase
Reset
Screen adj.
Auto configure
[V-Position]
[H-Position]
Phase G G 30
Reset
19