Advertisement
After ConversionSteps A, B and C have been completed,check the
INSTALLATION OF NATURAL GAS (BRASS) ORIFICES SPUDS.
appearanceof each burner's flame at the Hi and Lo settings against
Fig. 13. If the flames appear too largeor too small, revieweach stepto
4 BURNER MODEL (30" WIDE)
make sure it was completedcorrectly.
FLAME APPEARANCE AT HI AND LO
Fig. 14
Fig. 13
_._
.,
off
M_
oo
©©
o_
TO CONVERT
APPLIANCE
FOR USE WITH
NATURAL
GAS
Fig. 15
s BURNER MODEL (36" WIDE)
I
WARNING
I
Electricalpower and gas must be turned off priorto conversion.
if this appliancehas been convertedfor use with LP gas, each of the
lowingmodificationsmustbe performedto convert the unit back to
_tural gas.
A. Replace all orifice spuds
Perform Steps t through4 on page 5.
For Step 5: Locate the brass natural gas orifice spuds with small
C) ©
©
numbersstamped on theirsides that were odginallyinstalledin this
©
O
appliance before itsconversion for use with LP gas. Observe the
small numbers stamped on the sides of the spuds and note the
correctbumer locationfor each spud as shownin Figs. 14 and 15.
CompleteSteps 6 through9 on page 5 to completethe installation
of naturalgas main spudsin their correctionlocations.
Save the odficasremovedfrom the appliance for future use, They
willbe needed if this applianceis again convertedfor use with LP
gas.
Advertisement
