Sony HT-DDW885 Operating Instructions Manual page 30

Performing Auto Calibration
TV INPUT
DMPORT
SLEEP
VIDEO 1 VIDEO 2 VIDEO 3
SAT TV SA-CD/CD TUNER
2CH A.F.D.
1 2
4 5
7 8
>10/
-
0/10
CLEAR
DISPLAY
V
B
v
RETURN/EXIT
Press AMP MENU, then press
AUTO CAL.
Measurement starts in 5 seconds and the
display changes as follows:
A.CAL [5] t A.CAL [4] t A.CAL [3] t
A.CAL [2] t A.CAL [1]
While the time is counting down, stand away
from the measurement area to avoid
measurement error.
30
GB
TV ?/1
?/1
AV ?/1
?/1
switch
SYSTEM STANDBY
DVD
Input
buttons
MOVIE MUSIC
AMP MENU
AMP MENU
3
AUTO CAL
AUTO CAL
6
D.TUNING
9
D.SKIP
MEMORY DVD MENU
ENTER
FM MODE
MUTING
TOOLS
MUTING
TV VOL
MASTER VOL
b
MASTER
VOL +/–
MENU
The table below shows the display when
measurement starts.
Measurement for
Environment noise level
Speaker connection
Speaker level
Speaker distance
* The corresponding speaker indicator lights up in
the display during measurement.
The measurement process will take a few
minutes to complete.
When measurement ends, "COMPLETE"
appears on the display and the settings are
registered.
After you have finished
Disconnect the optimizer microphone from the
receiver.
Note
Auto Calibration cannot detect the sub woofer.
Therefore, all sub woofer settings will be
maintained.
Tip
The Auto Calibration function will be canceled
when you do the following during the measurement
process:
– Press ?/1, input buttons or MUTING.
– Change the volume level.
– Press AUTO CAL again.
Display
NOISE.CHK
MEASURE and SP
DET. appears
alternately*
MEASURE and
GAIN appears
alternately*
MEASURE and
DISTANCE appears
alternately*