Sony HT-DDW885 Operating Instructions Manual page 28

Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1,2
?/1
AUTO CAL
AUTO CAL MIC
MEMORY/ TUNING
ENTER MODE
VIDEO 3 IN/PORTABLE AV IN
PHONES
VIDEO L AUDIO R
3
1
Press ?/1 to turn off the
receiver.
2
Hold down ?/1 for 5 seconds.
"PUSH" and "ENTER" appears on the
display alternately.
3
Press MEMORY/ENTER.
After "CLEARING" appears on the
display for a while, "CLEARED"
appears.
The following items are reset to their
factory settings.
• All settings in the LEVEL, TONE,
SUR, TUNER, AUDIO, VIDEO and
SYSTEM menus.
• The sound field memorized for each
input and preset station.
• All sound field parameters.
• All preset stations.
• All index names for inputs and preset
stations.
• MASTER VOLUME is set to "VOL
MIN".
• Input is set to "DVD".
28
GB
MASTER VOLUME
DISPLAY INPUT MODE
INPUT SELECTOR
TUNING 2CH A.F.D. MOVIE MUSIC
DIMMER
Inserting batteries into the
remote
Insert two R6 (size-AA) batteries in the remote
commander.
• RM-AAU015 (Models of area code SP, AU
only)
• RM-AAU013 (Models of area code E51, AR
only)
Observe the correct polarity when installing
batteries.
MUTING
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix alkaline batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the remote buttons
may be reset to their factory settings. If this
happens, reassign the buttons again (page 64).
Tip
Under normal conditions, the batteries should last
for about 3 months. When the remote no longer
operates the receiver, replace all the batteries with
new ones.