Miele KM 3054 Operating And Installation Instructions page 47

The gas hob is normally suitable for
connection to either Town Gas, Natural
Gas or Liquid Petroleum Gas.
Depending on your country, the gas
hob is supplied ready for connection to
Town Gas, Natural Gas or Liquid
Petroleum Gas (see label on
appliance).
Depending on country, the appropriate
set of jets for conversion to an
alternative type of gas is included with
the hob.
Depending on the country, the gas
governor (MDG ELITRE with model no.
EL-125) comes with the hob.
If the jets you require are not supplied,
please contact your Miele dealer or the
Service Department.
Conversion to another type of gas is
described under "Conversion to another
type of gas".
Town Gas Connection:
Please use approved stainless steel
braided flexible tubing bearing EMSD
approval marking (such as EMSD
APPROVAL GTXXXX and gas cock for
connection connect from ½ " G
connector to governor, and connect up
to gas supply point.
LPG Gas Connection
Elbow joint connection
a b
a elbow join
b gasket
c nozzle
d ring
e rubber hose
The gasket depicted above is to pre-
vent gas leakage. After installation, turn
on the gas supply and use soap so-
lution (never use naked flame) to check
for gas leakage.
Warning
Under the Gas Safety (Registration
of Gas Installors and Gas Contrac-
tor) Regulations, only registered gas
installors (registered to the appro-
priate class) employed by registered
gas contractors can personally carry
out gas installation work. "Gas Inst-
allation Work" includes the fabri-
cation, connection, or replacement
of gas pipework, appliances and
fitting.
Please do not use aluminium cover.
Gas connection
c d e
47