Electrical Connection - Miele T 7744 C Operating Instructions Manual

Electrical connection

This tumble dryer is supplied ready for
connection to an a.c. single phase
supply. The machine is supplied with a
mains cable with moulded plug.
The accesibility of the plug must be
always ensured, in order to separate
the dryer from the mains.
The appliance should be connected up
only by a qualified electrician, in
accordance with national and local
safety regulations.
For extra safety it is advisable to install
a residual current device (RCD) with a
trip current of 30 mA.
The voltage, rated load and plug rating
are given on the data plate. Please
ensure that these match the household
mains supply.
Installation and connection
Important
The wires in the mains lead are
coloured in accordance with the
following code:
Green/yellow = earth
Blue = neutral
Brown = live
As the colours of the wires in the mains
lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
The wire which is coloured green and
yellow must be connected to the
terminal in the plug which is marked
with the letter E or by the earth symbol
z or coloured green or green and
yellow.
The wire which is coloured blue must
be connected to the terminal which is
marked with the letter N or coloured
black.
The wire which is coloured brown must
be connected to the terminal which is
marked with the letter A or coloured
red.
WARNING
THIS APPLIANCE MUST BE
EARTHED
41