Level The Washer; Installing Pad Strips; Complete Installation - Whirlpool CGD9060 Installation Instructions Manual

Level the Washer

Properly leveling your washer avoids excessive noise
and vibration.
1. Check the levelness of the washer by placing a level on the
top edge of the washer, rst side to side, then front to back.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, rst prop the
front with a wood block and adjust the feet as necessary; then
prop the back and adjust feet as necessary. Repeat this step
until washer is level.
2. Make sure all four feet are stable and resting on the oor.
Then check that the washer is perfectly level (use a level).
3. After the washer is level, use a 9/16" open-end wrench to turn
the nuts on the feet tightly against the washer cabinet.
IMPORTANT: All four feet must be tightened. If the nuts are
not tight against the washer cabinet, the washer may vibrate.
4. The washer should not move front to back, side to side,
or diagonally when pushed on its top edges.
5. Slide the washer to its nal location.
6. Con rm the levelness of the washer.

Installing Pad Strips

1. Take the 2 foam pad strips from bag.
2. Remove tape from the back of adhesive pads.
3. Install the pads on the left and right inside walls of the coin
vault, leaving about 1/4" (6 mm) to 1/2" (13 mm) of space
near the front edge of the vault to allow room for the coin box
to lock into position.
A. Foam pad strips
1. Check the electrical requirements. Be sure that you have the
2. Check that all parts are now installed. If there is an extra part,
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
7. Plug into an grounded 3 prong outlet.
8. To test and to clean your washer, measure 1/2 the detergent
A

Complete Installation

correct electrical supply and the recommended grounding
method. See "Electrical Requirements."
go back through the steps to see which step was skipped.
manufacturer's recommended amount of High Ef ciency (HE)
detergent for a medium-size load. Pour the detergent into
the detergent dispenser. Select any cycle and allow the
washer to complete one whole cycle.
9