Toyota Corola Owner's Manual page 135

■
When the power window does not close normally (driver's window only)
If the jam protection function is operating abnormally and a window cannot be
closed, perform the following operations using the power window switch on
the driver's door.
●
Vehicles without a smart key system: After stopping the vehicle, the window
can be closed by holding the power window switch in the one-touch closing
position while the engine switch is turned to the "ON" position.
Vehicles with a smart key system: After stopping the vehicle, the window
can be closed by holding the power window switch in the one-touch closing
position while the engine switch is turned to IGNITION ON mode.
●
If the window still cannot be closed even by carrying out the operation as
explained above, initialize the function by performing the following proce-
dure.
1 Hold the power window switch in the one-touch closing position. Continue
holding the switch for a further 6 seconds after the window has closed.
Hold the power window switch in the one-touch opening position. Con-
2
tinue holding the switch for a further 2 seconds after the window has
opened completely.
3 Hold the power window switch in the one-touch closing position once
again. Continue holding the switch for a further 2 seconds after the win-
dow has closed.
If you release the switch while the window is moving, start again from the
beginning.
If the window continues to close but then re-open slightly even after perform-
ing the above procedure correctly, have the vehicle inspected by your Toyota
dealer.
COROLLA_TMMMS_TMMC_U (OM12F00U)
3-5. Opening and closing the windows
135
3