Buick Enclave Owner's Manual page 149

2012
Hide thumbs Also See for Enclave:
Table of Contents

Advertisement

UNITS
Press the vehicle information
button until UNITS displays.
This display allows you to select
between English or metric units of
measurement. Once in this display,
press the set/reset button to select
between ENGLISH or METRIC
units. All of the vehicle information
will then be displayed in the unit
of measurement selected.
FRONT TIRES or REAR TIRES
On vehicles with the Tire
Pressure Monitor System (TPMS),
the pressure for each tire can
be viewed in the DIC. The tire
pressure will be shown in either
kilopascals (kPa) or pounds per
square inch (psi). Press the vehicle
information button until the DIC
displays FRONT TIRES kPa (PSI)
LEFT ## RIGHT ##. Press the
vehicle information button again
until the DIC displays REAR
TIRES kPa (PSI) LEFT ##
RIGHT ##.
If a low tire pressure condition
is detected by the system while
driving, a message advising you
add air to a specific tire will appear
in the display. See Tire Pressure on
page 10 45 and Tire Messages on
page 5 38 for more information.
If the tire pressure display shows
dashes instead of a value, there
may be a problem with your vehicle.
If this consistently occurs, see your
dealer for service.
COMPASS ZONE SETTING
This display will be available
if the vehicle has a compass.
See Compass on page 5 7 for
more information.
COMPASS RECALIBRATION
This display will be available
if the vehicle has a compass.
See Compass on page 5 7 for
more information.
Blank Display
This display shows no information.
I n f o r ma t i o n P r o v i d e d b y :
Instruments and Controls
Trip/Fuel Menu Items
(Trip/Fuel): Press this button
to scroll through the following menu
items:
ODOMETER
Press the trip/fuel button until
ODOMETER displays. This display
shows the distance the vehicle has
been driven in either kilometers (km)
or miles (mi).
To switch between English and
metric measurements, see UNITS
earlier in this section.
TRIP A and TRIP B
Press the trip/fuel button until
TRIP A or TRIP B displays.
This display shows the current
distance traveled in either
kilometers (km) or miles (mi)
since the last reset for each trip
odometer. Both trip odometers
can be used at the same time.
5-29

Advertisement

Table of Contents
loading

Table of Contents