Table of Contents
Advertisement
EPC612D8 Series
Data Bits
Use this item to set the data transmission size. he options include [7] and [8] (Bits).
Parity
Use this item to select the parity bit. he options include [None], [Even], [Odd], [Mark] and
[Space].
Stop Bits
he item indicates the end of a serial data packet. he standard setting is [1] Stop Bit. Select
[2] Stop Bits for slower devices.
Flow Control
Use this item to set the f low control to prevent data loss from buffer overf low. When
sending data, if the receiving bufers are full, a "stop" signal can be sent to stop the data
low. Once the bufers are empty, a "start" signal can be sent to restart the low. Hardware
low uses two wires to send start/stop signals. he options include [None], [Hardware RTS/
CTS], and [Sotware Xon/Xof].
VT-UTF8 Combo Key Support
Use this item to enable or disable the VT-UTF8 Combo Key Support for ANSI/VT100
terminals.
Recorder Mode
Use this item to enable or disable Recorder Mode to capture terminal data and send it as
text messages.
Resolution 100x31
Use this item to enable or disable extended terminal resolution support.
Legacy OS Redirection Resolution
Use this item to select the number of rows and columns used in legacy OS redirection.
Putty Keypad
Use this item to select Function Key and Keypad on Putty.
Redirection Ater BIOS POST
If the [LoadBooster] is selected, legacy console redirection is disabled before booting to
legacy OS. If [Always Enabled] is selected, legacy console redirection is enabled for legacy
OS. he default value is [Always Enabled].
63
Advertisement
Table of Contents
