Table of Contents
Advertisement
9 +12V TRIGGER IN
With this input triggered by a 12V DC supply, the M50 can be switched
ON remotely from standby mode by compatible devices such as
amplifiers, preamplifiers, receivers, etc. If the 12V DC supply is cut off,
the M50 will return to standby mode.
•
Connect this +12V trigger input to the remote device's
corresponding +12V DC output jack using a mono cable with
3.5mm male plug.
•
The controlling device must be equipped with a +12V trigger
output to use this feature.
+12V TRIGGER OUT
•
The +12V TRIGGER OUT is used for controlling external device that is
equipped with a +12V trigger input.
•
Use a 3.5mm mini-jack connector to pass +12V to a compatible
device equipped with +12V TRIGGER IN.
•
This output will be 12V when the M50 is ON and 0V when the unit is
either OFF or in standby mode.
10 WIRELESS (WIFI) ANTENNA TERMINAL
•
Install the supplied wireless antenna into this wireless antenna
terminal (WiFi).
•
For wireless connection to be established, ensure that the supplied
wireless antenna is installed and Wireless (WiFi) broadband router
with broadband internet connection is setup and available.
11 POWER
•
Supply AC mains power to the M50.
•
When the POWER switch is set to ON position, the M50 goes to
standby mode as shown by the amber status condition of the
Standby LED. Press the front panel Standby button or remote
control's [ON] button to switch ON the M50 from standby mode.
•
If you intend not to use the M50 for long periods of time (such as
when on vacation), switch off the POWER switch.
•
With POWER switched off, neither the front panel Standby button
nor remote control's [ON] button can activate the M50.
12 FUSE HOLDER
Only NAD service personnel can access the fuse holder in the unlikely
event a fuse may need to be replaced. Refer all servicing to authorized
NAD service centers.
13 AC MAINS INPUT
The M50 comes supplied with two separate AC power cords. Select the
AC power cord appropriate for your region.
•
Before connecting the AC power cord's plug to the wall outlet,
connect firmly first the other end of the AC power cord to M50's AC
Mains input socket.
•
Always disconnect the AC power cord's plug from the wall outlet
first, before disconnecting the cable from the M50's AC Mains input
socket.
IDENTIFICATION OF CONTROLS
11
Advertisement
Table of Contents
