Coolant Level - CITROËN C3 Handbook

Checks

Coolant level

The coolant level should be close
to the "MaX" mark but should never
exceed it.
When the engine is warm, the temperature of
the coolant is regulated by the fan.
The cooling fan may start after
switching off the engine : take care
with articles and clothing that might
be caught by the fan blades.
In addition, as the cooling system is pressurised,
wait at least one hour after switching off the
engine before carrying out any work.
To avoid any risk of scalding, unscrew the cap
by two turns to allow the pressure to drop. When
the pressure has dropped, remove the cap and
top up the level.
Changing the coolant
The coolant does not have to be replaced at routine services.
Fluid specification
The coolant must conform to the
manufacturer's recommendations.
138
Screenwash fluid level
Top up the level when necessary.
Fluid specification
For optimum cleaning and to avoid freezing,
this fluid must not be topped up or replaced
with plain water.
In wintry conditions, it is recommended that you
use an ethyl alcohol or methanol based fluid.
Additive level (Diesel with
particle emissions filter)
according to your version of instrument panel,
the additive reservoir low level is indicated by:
- fixed illumination of the particle
emissions filter warning lamp,
accompanied by an audible signal,
or
- fixed illumination of the service
warning lamp, accompanied by an
audible signal and a message that the particle
emissions filter additive level is too low.
Topping up
The reservoir must be topped up without delay
by a CITROËN dealer or a qualified workshop.
Used products
avoid prolonged contact of used oil or
fluids with the skin.
Most of these fluids are harmful to
health or indeed very corrosive.
do not discard used oil or fluids into
sewers or onto the ground.
Take used oil to a CITRoËn dealer or
a qualified workshop (France) or to an
authorised waste disposal site.