System preparation
Make sure to unplug the AC power lead before in-
stalling the sound bar or changing the position.
Using spike legs
1
Peel the double sided tape separator.
Spike leg
2
Fix the spike leg onto the sound bar as
shown.
Bottom of
sound bar
To mount the sound bar on the wall
Caution:
Be very careful to prevent the sound bar [2.3 kg
●
(5.1 lbs.)] from falling when mounting on the wall.
Before mounting, check the wall strength. (Do not
●
put on the veneer plaster or whitewashed wall. The
sound bar may fall.) If unsure, consult a qualified
service technician.
Mounting screws are not supplied. Use appropri-
●
ate ones.
Check all wall mount angle screws for looseness.
●
Select a good location. If not, accidents may occur
●
or the sound bar may get damaged.
SHARP is not responsible for accidents result-
●
ing from improper installation.
■ Driving screws
SHARP designed the sound bar so you may hang
it on the wall. Use proper screws (not supplied).
See below for size and type.
3.2 mm
5 mm
22 mm
Double sided
tape separator
9 mm
■ Installing the sound bar
1
Fix the pattern paper to the wall in hori-
zontal position as below.
548 mm
Wall surface
44 mm
2
Make a hole on the wall following the screw
point marks on the pattern paper by using
a drill.
8-9 mm
3
Fix a wall mount plug into the hole using
a hammer, until it is flush with the wall
surface.
8-9 mm
Wall sur
4
Fasten the screws to the wall as shown below.
(Total screw is 2 pieces)
Wall surface
Wall surface
5
Hang the sound bar onto the screws.
6
509 mm
Pattern paper
(supplied)
32 mm
Wall surface
32 mm
face
Screw using
screwdriver
4.5 mm - 5 mm
Gap from wall
surface