Standard Features - NEC Express5800 series User Manual

STANDARD FEATURES

High performance
®
Intel Xeon™ Processor
DDR2-400 SDRAM (interleave type)
High-speed
1000BASE-T/100BASE-TX/10BASE-T
interface
(1Gbps/100Mbps/10Mbps supported)
High-speed disk access
(Ultra320 SCSI)
Management Utilities
NEC ESMPRO
NEC DianaScope
Adaptec Storage Manager - Browser
Edition
Maintenance Features
Off-line Maintenance Utility
Memory dump feature using the DUMP
switch
General Description 2-3
Expandability
One low profile 64-bit/133 MHz riser slot
Large memory of up to 8 GB
Two SCSI hard disk drive bays per CPU
module
Up to two multi-processors are available
for upgrade.
Two USB (Ver 1.1) interface ports
Two giga-bit network ports
High-reliability
Memory monitoring feature (single-bit
error correction/multiple-bit error
detection)
Fault Resilient Boot (FRB) feature
CPU degradation feature (logical
isolation of a failed device)
Bus parity error detection
Temperature detection
Redundant cooling fans (hot-swappable)
Error notification
Standard RAID controller (RAID0/ RAID
1)
Auto-rebuild feature (hot-swappable)
BIOS password feature
Internal fan monitoring feature
Internal voltage monitoring feature
Redundant power supply (optional,
hot-swap)
Mechanical security lock
Many Available Features
Software power-off
Remote power-on feature
AC-Link feature
Baseboard Management Controller
(BMC)
Self-diagnosis
Power On Self-Test (POST)
Test and Diagnosis (T&D)
Easy and Fine Setup
ROM-DOS system disks (system
management tools)
NEC EXPRESSBUILDER (system
management tools)
SETUP (BIOS setup utility)
SCSISelect (Standard SCSI and RAID
configuration utility)