Spare Wheel - BMW M5 Owner's Manual

the vehicle, and never start the engine while it is
supported by the jack.<
What you will need
To avoid rattling noises later on, note the posi-
tions of the tools before removing them, then
return them to their initial positions after com-
pleting work.
*
1 Chock
*
2 Vehicle jack
*
3 Lug wrench
The tools are located in the hollow of the spare
wheel.

Spare wheel*

1. Pull back lock 1, fold open tensioning lock 2
completely and loosen the belt 3.
2. Remove the cover 4.
3. Remove the tool mount form the spare tire
and stow the belt in the net bag included if
necessary.
4. Remove the spare wheel.
202
Online Edition for Part no. 01 41 2 602 697 - © 08/09 BMW AG Online Edition for Part no. 01 41 2 602 697 - © 08/09 BMW AG
Preparing wheel change
1. Observe the safety precautions above.
2. Prevent the vehicle from rolling:
Place the chock behind the front wheel on
the other side of the vehicle, or on inclines,
in front of this wheel. On steeply inclined
roads, always secure the vehicle against
rolling.
3. Loosen the lug bolts a half turn.
Jacking up vehicle
1. Position the vehicle jack at the jacking point
closest to the wheel so that the entire sur-
face of the jack base rests on the ground
perpendicularly beneath the jacking point.
The vehicle jack is designed for
changing wheels only. Do not attempt
to raise another vehicle model with it or to
raise any load of any kind. To do so could
cause accidents and personal
2. Guide the jack head into the rectangular
recess of the jacking point when cranking
up, refer to illustration detail.
3. Jack the vehicle up until the wheel you are
changing is raised from the ground.
Mounting a wheel
1. Unscrew the lug bolts and remove the
wheel.
2. Remove accumulations of mud or dirt from
the mounting surfaces of the wheel and
hub. Also clean the lug bolts.
3. Position the new wheel or spare wheel.
Secure the wheel by screwing at least two
lug bolts into opposite bolt holes.
When you mount wheels other than Genu-
injury.<