Table of Contents
Advertisement
SETTINGS
ADJUSTING THE RING VOLUME
The phone needs to be in stand-by mode (
Press the
and
The ring volume changes each time you press.
There are six levels. You will hear the ring tone for each level you select.
CHANGING THE CONFERENCE KEY
A request must be sent to the PBX to connect a three-way call. R3 (Flash 3) is the standard
and it works in most countries and with most PBXs. If you experience problems creating a
three-way call, this command may need to be changed as described below. Please contact
the telephone administrator in your company or your service provider for further information.
Press and hold the
You will hear a tone confirming that you are in the conference setting mode.
Press the digit or sequence required by your PBX.
Press
.
You will hear a tone confirming that the setting has been saved and that you have exited the
setting mode.
You can exit the conference setting mode by pressing
SETTINGS IN SETTING MODE
There are a number of settings you can change by first putting the phone in setting mode
and then entering a command followed by
To enter the setting mode, press
You can exit the setting mode by pressing
Changing the Flash/R-pulse time (1)
Flash/R-pulse (Register recall) is used to request a new line from the PBX. Different
countries and PBXs may require different durations for activating the Flash/R-pulse. Duration
requirements should be specified in the technical data for the PBXs.
Applicable values:
Press
.
You will hear a tone confirming that you are in setting mode.
keys.
key for three seconds.
and a value followed by
with the phone in stand-by mode (
1 = by region (standard)
2 = 60 ms
3 = 100 ms (Scandinavia, Europe, Siemens HiPath)
4 = 200 ms
5 = 300 ms
6 = 400 ms (Germany, France, Israel)
7 = 500 ms (USA)
8 = 600 ms
) when you change this setting.
or waiting for 10 seconds.
or waiting for 10 seconds.
8
as instructed below.
).
Advertisement
Table of Contents
